GEARWURX ARM 3.0 ROBOTIC MANIPULATOR

$5,999.99

FREE SHIPPING

For U.S. orders only

WORLDWIDE SHIPPING

Price will be calculated at checkout

FINANCING AVAILABLE

You can finance this product at checkout

Categories: , , SKU: 9416163

Description

GearWurx ARM 3.0 Robotic Manipulator

The ARM 3.0 improves on the ARM 2.0(DISCONTINUED) with better position sensors, more robust linear actuators, and more powerful motor controllers. This 6 degree of freedom arm uses linear actuators and rotary servos to provide an operation envelope of over 7 ft in diameter. Sealed ball bearings provide precision movement at each joint. The lower 4 joints use absolute encoders for precise, linear control. Typical current draw at full capacity is approximately 7 amps. Rotation speed of base joint is 60 degrees / second.  Wrist rotates 240 degrees in 2.3 seconds. Gripper moves from fully open to  fully closed in less than 1 second. Reverse power protection and over-current protection is built into to the unit. A power switch with green LED “on” state indication is located on the electronics enclosure. See below for mounting pattern and refer to datasheet below for signal pinout and additional information.

Configuration

  • ARM 3.0 Closed-Loop Position Control: All joints operate in a closed loop position control mode All joints are PWM ready if you choose to command from your microcontroller or from an RC radio All joints utilize absolute feedback. This version of the ARM is best suited for applications where the ARM will be under computer control and where the computer will send a PWM command to the each joint of the ARM to go to a specific position. The ARM will then hold that position.
  • ARM 3.0 Open-Loop Velocity Control: All joints in this version of the ARM operate in open-loop velocity mode. This ARM is most friendly when using a joystick or radio control unit to allow a human operator to directly control the ARM. When connected to a radio or one of our joysticks, this ARM will hold position when the joystick is centered and will begin to move as the operator moves the joystick from center. The more the joystick is moved from center, the faster the ARM will move. If the joystick is moved in the other direction, the ARM will reverse directions. An RC-PWM signal is input into the ARM allowing fully proportional control of all six of the ARM degrees of freedom. This version of the ARM can run out-of-the-box by connecting 12VDC power and any standard RC radio to the input connector.

Specifications

  • Reach envelope: 86.6 in (2.2 m) diameter
  • Lift Capacity: 10 lbs (4.5 kg) at full extension
  • 6 Degrees of Freedom
  • Weight: 20.4 lbs (9.2 kg)
  • Interface: RC PWM
  • Holds position with power off
  • Input: 12 VDC, 7.5A Peak

Additional information

Weight 9.2 lbs
Reach envelope

86.6 in (2.2 m) diameter

Lift Capacity

10 lbs (4.5 kg) at full extension

Degree of Freedom

Degree of Freedom6

Interface

RC PWM

Input

12 VDC, 7.5A Peak

Configuration

Arm 3.0 Closed-Loop Position Control, Arm 3.0 Open-Loop Velocity Control

Reviews

There are no reviews yet.

Be the first to review “GEARWURX ARM 3.0 ROBOTIC MANIPULATOR”

Your email address will not be published. Required fields are marked *

Post comment